installation of new windows completes the installation of slopes on the windows, and the installation of low tide.If ebbs and slopes you decide to be ordered separately, be sure to use the company's products Veka, Danke, or Montblanc.
- slopes Installation of plastic windows Installation of plastic
- window sills
- Installation window sills
- VIDEO: Set on the slopes of plastic windows
- Price question
Setting slopes on plasticWindow
plaster eventually crack and shrinkage house surface damage will be even more noticeable. If necessary, plastering the width of more than 3 cm mandatory set fittings.Install window slopes of plaster required plaster after primed surface, putty and paint or wallpaper paste over the slopes.Such slopes will require frequent repair - at least once in 3 years the surface slopes will need to paint a fresh coat of paint.
Plaster slopes provide better insulation than the plaster, but more afraid of moistur
This is the fastest and most affordable way to close the window slopes - and you can do this with your hands.If necessary, insulated soffits.The service life of the coating is at least 15-20 years, it is also extremely easy to clean.
installation of this type specifically consider the slopes.
installation of plastic slopes
Installation of plastic window slopes need to start with the installation of the top panel.
completing the measurements, cut the required plate and try on.
plastic panels are mounted on the mounting foam in several phases: a continuous layer covering the points of the slope and panel junction box, then drying foam fill the remaining gap.At the time of drying foam slope masking tape attached to the wall.Do not apply too much foam.Remember threefold expansion of the mounting material!
Set sill on technology similar to assembling the top panel of the slope.After applying the foam sill must be uniformly pressed in several places and leave the goods at least 12 hours.
vertical measurements of the window opening, cut the two side panels slope.Lower should be adjusted by an angle of 90 °, and the upper faces panels - respectively with the upper part of the slope.
process of fixing the mounting foam is similar.
papered wall panel joints and decorative corners.
Note that all three panels and sill have to go out the window.
To this end, the gaps between the frame and the wall cut small grooves, remnants of foam removed.
At the end joints of the panels and the window sill was treated with sealant.
This installation slopes of plastic windows is completed.
several types of window sills:
- aluminum ebbs;
resistant to environmental influences.Able to withstand temperatures from -40 ° C to + 80 ° C.
- galvanized tides;
most economical option.It has an excellent decorative and mechanical properties.
- copper ebb;
most durable material for the tide.Not cheap.
- plastic ebb.
Easy to clean and install, economical.
Installation window sills
You will need:
- stationery knife;
Trim any excess foam from the outside of the window.
is plugged on the tide and make measurements: there should be no large gaps between the wall of the house and shade.
if necessary, to ensure greater waterproofing under reflux attach PSUL.
Ebb record softwood 4 to 20 mm ("ê").
joints treated with sealant.
tide mounted, head under the window, with a slight slope to the moisture that falls on the low tide, it does not flow into the seam between him and the window frame.
VIDEO: Set on the slopes of plastic windows
$ Price question
price setting tides:
Kiev - 120 UAH.per meter.
Moscow - from 600 rubles.per meter.
price of finishing slopes:
Kiev - 350 UAH.
Moscow - 1 600 rubles.