One of the most popular packages is the satellite dish with three convectors.
Installing a satellite dish is possible without the use of additional equipment, and connect and configure the receiver to the power of each of us.
- Satellite TV: Benefits
- principle of operation of the antenna
- There are two kinds of plates
- installation of satellite antennas: mounting options
- set of satellite TV
- Preparation Equipment
- Mounting the satellite dish with respect to elevation
- Installation F-connectors
- correct setting plates with their hands
- Installing a satellite dish Tricolor TV
- $ Installing a satellite dish Tricolor TV: price
- Installing a satellite dish yourself
- Installing a satellite dish with their hands: siting of the
- $ Installation of satellite dishes: the price issue
- Installing a satellite dish: VIDEO
standard satellite - Sirius, Amos and Hotbird - today broadcast 72 channels.
Satellite TV: Benefits
subscription fee, inherent in, for example, all cable TV channels, for satellite television is not introduced.The only cost to pay off over time - installing a satellite dish.
- image quality.
- Selecting channels.
Standard bundle on three satellites -Amos 4.0W, Sirius 5.0E, Hotbird 13.0E - provides a range of channels to suit all tastes.
technology of satellite television is constantly evolving because every year becomes more and more satellite TV channels and, of course, and users.
principle of operation of the antenna
on the mirror surface of the antenna gets satellite signals.
reflecting it enters the converter.
converter sends a signal to the satellite receiver.
signal comes through the receiver to the TV.
There are two kinds of plates
- Offset and set the direction of the plate is not strictly on a satellite, and slightly below him, as reflected from the surface of the satellite dish signal enters the converter at a certain angle.Such antennas are fixed in most cases almost vertically to prevent the gathering of precipitation.
- direct focal plates are arranged in a different way: convert them partially covers the surface of the mirror.
IMPORTANT! most frequently used plate and receiver Svec - reliability and practicality of products is confirmed by a dozen years in the market providing satellite TV services.
installation of satellite antennas: mounting options
need to install a satellite dish, correctly choosing the place: standing in the way of receiving the signal tree can cause poor reception and in some cases completely prevent it.
antennas on three satellites must be configured in the south-west.
set of satellite TV
- Mirror (plate) is necessary to receive the signal.Diagonal dish must be at least 60 cm (some models diagonal mirror is 1.2 m).The choice depends on the diagonal of the terrain and obstacles standing in the way of satellite reception.
- head (converter) converts the signal reflected from the dish, and sends it to the receiver.There converters with different number of outputs, allowing to connect one, two or more receivers simultaneously.
- DiSEq connects several converters.
- DVB-Receiver - the entire set of precisely that part of the most expensive.For a signal to be enough free channels and the receiver type Globo, however, to receive pay channels should be used receivers with card reader.
- F-connectors connect the cable converters, receiver, DiSEq and other components of the system.Standard installation scheme involves the use of 8 pieces.
IMPORTANT! To isolate the compounds F-connectors and cables will need to buy an additional heat-setting, as well as anchors to attach the brackets to the wall.
determined on the area with the location of the world.The figure below is indicated approximate location of the south at different times of day (for Kiev).Navigate by the sun, of course, possible only in clear weather. more accurate readings can be obtained by compass.
IMPORTANT!About concrete wall compass can fail badly.Also note that the satellite NTV + is always in the south, and the satellites Sirius, HotBird and Amos - roughly in the south-west (in Kiev).
Determine the visibility of the satellite at the installation site.
ideal option, eliminating the possibility of interference - Installation of a satellite dish on the roof. undesirable to attach the plate to the bar of collective antennas, pipes gas flues.Attachment, however, is possible to the wall of the elevator shaft.
satellite dishes can not be installed under a canopy roof if the apartment windows face south-west or south: visor simply block the signal.In addition, precipitation falls from the visor may change the position of the antenna.Optimally mount plate, in the case of the south or south-west side, on the outside balcony.
If you install a satellite dish on the facade of the building, you may need permission from arhstroykontrolya and sample project installation.
IMPORTANT! case of theft of satellite antennas from the roofs are frequent.If there is the option to install the plates on the wall of a building, it is better to choose it.
Mounting the satellite dish with respect to elevation
collect satellite dish (user's manual and the rules of the assembly are attached to each product).
Secure bracket.The choice of fixing elements (anchor bolts, nuts, screws, and so on. D.) Should be based on the expected wind load and the wall material, which is being installed satellite antenna.
Set converters in the holder in a position connector down: atmospheric moisture after installation should not get into the converter.
Attach the cable to the converter using the F-connectors.
Attach the cable to the arc of the convector plates with plastic cable ties or adhesive tape.
Seal F-plug connection.Is required to perform the sealing adhesive tape in two layers over the entire length.On top of a layer of sealant tape (better to use silicone).
antenna mounted on the bracket.Tighten the adjustment nuts: after installation, you should be able to move the antenna with little effort both vertically and horizontally.
IMPORTANT! If the calibration plate relative to the position of a satellite in your plans do not include, you can install the antenna with your motor performing adjustment to the location of the satellite automatically.
cable is attached to the bracket, also using plastic ties or adhesive tape.
IMPORTANT! near the antenna should be left margin cable length of 1 m, securing it to the bracket.
Figure 4 - Device antenna
remove the top of the cable insulation by 15 mm.It is important not to damage the braided shield.
braided shield is positioned along the cable.
foil placed along the shielding.
removes a layer of insulation inside of about 10 mm.
wind the jack until it stops (see. Photo 4).
IMPORTANT! center conductor must not protrude beyond the connector by more than 2 mm.If a length greater than 2 mm, the excess "bite."
correct setting plates with their hands
Approximately set the azimuth angle and elevation angle (azimuth compass exhibit).
Connect the cable to the satellite receiver (manual should clearly explain this step) - cable must go from the converter or DiseC.F-connector is processed in a manner which we discussed above.
digital receiver connected to your TV.Turn on the receiver.
IMPORTANT! Digital satellite receiver with the purchase has to be programmed on the TV satellite (Sirius, Amos, Hotbird - for conventional plates or, for example, on the Yamal 201 - Plate with your motor).From the list of channels receiver to select any "open" channel with the signal from the satellite.
translational not strong jerks move the mirror plates vertically / horizontally about the estimated location of the selected point to the use of satellites.As a result, the column should appear (Quality Score) and the TV picture on the TV screen.
IMPORTANT! When you turn on the degree of biding to 5 seconds.- During this time, the signal from the satellite should reach your antenna.
menu, scroll to the satellite receiver "Signal strength" and activate it.The maximum value of the signal level can be achieved by gradually moving the antenna mirror vertically / horizontally.
IMPORTANT! signal level will depend on the weather conditions.
adjusting nut must be tightened by controlling the level of signal received by the system.
When setting up the antenna on the reception of the signal from the satellites Sirius, HotBird and Amos, configure the appropriate converter by switching on the receiver the received channel to the corresponding custom at this time companion.
Installing a satellite dish Tricolor TV
include satellite systems to provide customers all over the country and far beyond its borders signal quality, the most popular is the system of Tricolor TV.
advantage of the system, in addition to excellent signal and thousands of audience members that you do not need a challenge to master: visual instructions and simple installation system, even for dummies will be clear and easy to perform.Self-installation and configuration takes less than 2 hours!You do not need any special knowledge of the organization receiving the signal, no specific equipment: all you need for the installation is supplied.
$ Installing a satellite dish Tricolor TV: price
cost antenna installation Tricolor TV FULL HD is approximately $ 300.This price includes the payment for the full set of equipment, the package Maximum HD (170 channels, 24 of which are shown in the format FULL HD), the installation of the antenna, check the decoder as well as the activation of the card access system Tricolor subscription.
popular network of satellite television are also considered Raduga TV and Telecard TV.
The official website of the network Rainbow TV you can find a special program, "Assistant installer» , which detailed painted all the highlights of the installation of satellite television antennas, as well as a base for setting the signal reception.
Installing a satellite dish yourself
You will need:
- Ring spanners 10 (used in the assembly of the antenna, as well as to fix the plate in elevation);
- spanner 10 (used in the assembly);
- key 13, an L-shaped end (used when installing the antenna azimuth);
- wrench (used if the antenna is attached to the anchor);
- Phillips screwdriver;
- pliers (used when cutting the coaxial cable, as well as plastic cable ties);
- hammer SDS-plus (used when drilling mounting holes in the wall);
- perforating drills for d = 12 mm, length - from 120 mm to 180 mm;
- building magnetic level;
- small TV with low frequency input (used when not at hand special tuning priborov- satfainderov Openbox SF-10, SF-20 or SF-30);
- satellite receiver;
- electrical tape;
- plastic ties (used when attaching cables);
- 40 cm plastic corrugated pipe d = 10 mm (used in the organization of cable protection against chafing on the way down from the roof);
- cap screws Bolts (6 pcs.) 13 with plastic dowels, length - 60-80 mm;
- thick and wide metal washers d = 30/50 mm - 4-5 pcs.(Used in the alignment of the antenna).
Installing a satellite dish with their hands: siting of the
$ Installation of satellite dishes: the price issue
What is satellite TV?
Everything will depend on several factors such as the number of TVs to be connected to the antenna:
Kiev - 950 UAH., 1550 UAH., 2100 UAH.and 2 400 UAH.for 1, 2, 3 and 4 respectively televisions.
Alternatively, the diameter of the antenna:
Moscow - 2500 rubles., 4 000 rubles.and 6000 rubles.Antenna 0.6 / 0.9 / 1.2 m, respectively.
Raschetstoimosti may also take into account a fee for the installation in a remote location, install your motor, dismantling dishes, as well as the setting of the installation.
Installing a satellite dish: VIDEO