Electrification any premises requires preparation and care.But there is a structure and a zone in which the risk of short circuit is increased by virtue of the base material, network load, humidity and other conditions.
- Posting cottage
- wiring in the garage
- wiring in the garage, video
- Wiring in the bathroom Wiring
Cottage - is often, a wooden structure, most of the work in which the owners operate their own hands.If the wiring in the summer cottage owners decided to perform his own, then you need to know how to carry out the wiring correctly.
wooden buildings acceptable for concealed wiring in metal pipes, but to give this option is too expensive.Therefore, the wiring in the country is carried out openly.
the cheapest way - laying wire special cable channels.If the cottage is a fully Equipped country house, you can select open wiring on insulators.Cable and wiring products for the retro-wiring are quite expensive, so do such a sense wiring in
wires for wiring selected villa with reinforced insulation, do not support combustion and low smoke generation.The principles of how to make input in the cottage is the same as when you enter into any wooden house.
Note that wood used only copper wires. If external wiring elected aluminum SIP, it can not pass through the wooden walls: an offshoot of the power line conducted them to the walls of cottages and directly himself entering carried copper cable attached to the aluminum special clamps.
are reading: Posting in wooden house
wiring in the garage
in how to properly carry out their own hands the wiring in the garage, in principle, there is nothing new with respect tohow to perform external and internal wiring in homes.
order to plan how to conduct electricity, wiring diagram drawn up in the garage.About how to make cable entry to the garage and the connection to the shield, it must ensure a professional electrician.
Internal wiring runs hidden, if the walls are made of brick or concrete.In this case, the plaster cut Grooves, wires are laid in them and are sealed plaster, comparing with the wall. the metal walls of the wiring attached garage open way .
Due to the garage powerful devices, such as welding machine should be selected sootvetstvuyushaya wires and sockets.Wires leading to the consumer, calculated depending on their capacity. sockets can be purchased splash - with a lid. wiring must be carefully protected from moisture.Be sure to take care of the grounding and the RCD.
wiring in the garage, videos:
Wiring in the bathroom
in how to spend their own hands wiring in the bathroom there are a few mandatory rules.
- The bathroom should not be in junction boxes and switches; they are located only in the hallway.
- outlets in the bathroom is also not desirable, if they are installed, the only splash-proof, and only in the third zone (in the figure below).
- wire to a lamp extends from the junction box in the hallway through a hole in the wall.In small bathrooms light is usually located above the entrance door. wiring in the bathroom, in a damp room, should be minimal.The wire to the lamp lasts for as short highway.
The question is how to do the wiring in the bath with his hands, even more complicated.In addition, how to hold the wiring in the bath and apply the recommendations to conduct electricity in the wooden house and for the electricity in the bathroom.
Wiring complicated by the fact that in addition to combustible base and moisture, there is also a strong factor in the heat.Keep in mind that over the stove lead wires can not be .Wire selected non-flammable and heat-resistant.
Like the bathroom, wiring accessories can not be installed directly in the steam room.Junction boxes, sockets and switches with a high degree of protection installed in the dressing room. lamp for steam must be at least IP-44 protection degree. low-voltage lights can be set accordingly with the step-down transformer.