Among modern decoration and building materials almost none of these, which are not affected by mold.Everywhere there are microscopic spores, and after getting into a favorable environment, they immediately begin to grow.But these black and green spots on the walls are the strongest allergens that trigger a variety of diseases.The fungus spreads across the surface quickly enough, so you need to start to fight the fungus on the walls as soon as possible.In this connection, it is recommended to take measures to eliminate the mold and create conditions that prevent her re-education.And you just know that this should be done.
- reasons for the appearance of fungus
- Chemicals against mold
- Folk remedies from plaque
- Getting rid of mildew fungus to
- not appear
Causes of the fungus
So, the first sign of the presence offungus in the house are dark green spots on the walls and ceiling, peeling wallpaper, crumbling plaster and odo
If we are talking about the humidity in the room, the moisture is most likely to occur as a result of faulty ventilation system.Particularly susceptible to infection by the fungus are the places where the air ventilation is poor.How paradoxical sounds, plastic windows, which are characterized by high density, only aggravate the situation and the problem that is associated with poor ventilation and poor indoor climate.When there is insufficient air movement condensate settles on the walls and ceiling, a sample of a perfect environment for fungal spores.
Another cause of mold is emerging subfield moisture that penetrates the wall of the building.The emergence of the fungus is considered a signal that not only the walls are infected, as well as the land under the house.The presence of moisture that comes from the ground, can be seen on the drip in the joints of the walls to the floor of the basement or first floor.The fungus can occur because of an error in laying the insulation of horizontal and vertical foundations.In this case it is necessary to perform an examination of insulation condition of the foundation walls.You have to make it repair, if it is damaged.
development of fungi contributes to the state water sanitation, and the first symptoms are the presence of moisture, which occurs along the passage of pipes and footprints on the wall next to the bathroom.Leaking gutters and drains can be found only from the outside like streaks on the plaster.But when the humidity is big, for example, during heavy rains, there are also streaks of center.If the edges of the walls and in the corners noticeable dark patina, you can be sure what happened freezing wall.
against mold fungus is able to equally distributed on the surface of wood and brick.The situation with brick - less serious, because in this case, the mold is removed easily.When it comes to wood, the only solution would be cutting and burning of sites contaminated by a fungus.The rate of propagation of mold hit.During the year, it can destroy wood by 70%.In this case, the fungus as dangerous for furniture and structural elements in connection with what is recommended to act prophylactically.All elements made of raw wood, should be mandatory to process special means of the fungus on the walls to drift into the room.
With the development of chemistry is very easy to find drugs that can help you cope with the spreading fungus.These are special sprays, which should be sprayed on the surface that struck mildew.During the procedure, try not to get these substances to the skin, because they can cause burns.And it is better not to spray the spray on unaffected areas as may stain.To this end, Nestle clean surface with old newspapers or plastic wrap.So antiseptic against fungus on the walls do not will be spread or harm.
spray application is carried out in several successive stages: antifungal treatment with a mixture of ceiling or wall section, removing mold fungus with a stiff brush and drainage of surface construction hairdryer.Subsequently, in order to prevent the re-emergence of the fungus is often recommended to ventilate the room.
Folk remedies from plaque
rid of the fungus, you can use a solution of copper sulfate (no more than 100 grams of sulfate per 10 liters of water).But keep in mind that this solution can give the surface a blue tint.Often when the owners are interested in the question of how to bring the fungus from the walls, instead of using bleach sulfate solution, and the various bleach for laundry.It should be remembered that the chlorine-containing substances can not in any event be mixed with drugs, which in its composition contain ammonia.
fungi in mild cases can be treated with a concentrated solution prepared with soap, which contains alkali in its composition, or a solution made based on tea tree oil 2 teaspoons of oil to take 2 tablespoons water, sprayed onto the mold from a spray or rinse.To control you can use vinegar and baking soda.Mould sprinkled with baking soda and vinegar, then sprayed.The substances react with each other and begin to bubble.
How to get rid of the fungus
rid of the fungus, in fact, can do without the walls of the fungus treatment with special preparations.To do this is to remove the cause of its appearance and make the habitat unfavorable for the spread of mold spores.The main reason for the emergence of a black plaque - damp walls and humidity indoors where air can not circulate freely.
winter and autumn window crying because they have an impact on the cold side of the street and the heat - from the room.Good insulation of plastic windows combats noise, cold and insects, but because of this becomes almost impossible air exchange between housing and street.The humidity in this case is increased, and the air stagnates.To create a favorable climate and the fight against mold regularly ventilated room and well heated.Batteries must be covered sills not more than 2/3.
for warming wooden frames can buy special pads created from sponge and profile foam or rubber.It can be used for thermal insulation of windows and special woolen "Finnish" string, which is in the cotton shell.Other methods known to use cotton rolls, which are placed between the window frames to absorb excess moisture and insulation.Salt also gives good results: it can be placed in the opening of the jar and put between the frames.
To get rid of mold and mildew on the walls is necessary to ensure good ventilation of the room by installing an exhaust fan or clean air moves in older homes, which helps to reduce humidity.Next, the maximum dry air and remove plaque from the ceiling, walls of the corners and crevices.If the walls of the room are covered with plaster, it would have to clean up the concrete base completely, because the debate has already penetrated into the structure.
For good rule should also take timely repairs.So you need to do major repairs every 15 - 20 years, and beauty - to fulfill every 4 - 6 years, which will be a reliable guarantee the absence of such troubles as dark spots on the walls.
to the fungus has not appeared
getting rid of mildew on the walls, it is important to make sure that it never occurred in your home.To do this, it is to adhere to simple rules that are considered key to the absence of microbial structures that have a direct harm to all living in the house:
- The room should be plenty of natural light.Open curtains and blinds during the day.
- in the kitchen and bathroom ventilation should be open without fail.
- humidity in the house should not be more than 35%.Better to keep the bathroom door open to all the rooms there was always the same humidity.
- least two times a day is necessary to ventilate all the rooms, opening windows wide.
- Once a month the floors and walls is cleaned with anti-fungal solution.
- preventing overcooling the room and not in the room to hang wet clothes.
- recommended time to repair the water pipe and valves.
- for repair is better to use materials that are resistant to water.
- When installing plastic windows need to install a ventilation system.
- When installing furniture sets near the walls is necessary to leave a small gap for air circulation.
- Try not to keep in the house of violets and geraniums, because they are the epicenter of the reproduction of various fungi.
combating fungi in private homes and apartments are not going on for decades, but it should understand what dangerous fungus on the walls, and that eliminate the cause of the mold is much easier than to deal with the negative consequences.Moreover, to get rid of black deposits on the walls is much easier and simpler in the initial stage of its formation.It is timely to eliminate mold will keep you and your family's health!